Before you start
Never put your hand into the disposal, and make sure the switch is off before you begin. If you smell gas or see water pooling near an outlet, stop and call us.
What you'll need
A flashlight, tongs or pliers, and the small hex wrench that came with the disposal. The wrench is usually clipped to the underside of the unit or taped inside the cabinet door.
Steps
1. Turn it off at the switch
Flip the wall switch off. If your disposal has a plug under the sink, unplug that too.
2. Look inside with a flashlight
Bones, fruit pits, and cutlery are the usual culprits. Remove anything visible using tongs or pliers—never your fingers, even with the power off.
3. Free the flywheel
Insert the hex wrench into the six-sided socket on the underside of the unit and work it back and forth until it turns freely.
4. Press the reset button
Press the small red button on the bottom of the unit firmly. It may have popped out when the motor overloaded.
5. Restore power and test
Plug it back in, switch it on, and run cold water while testing. If it hums but does not turn, stop and submit a maintenance request.

These steps are optional and for general guidance only. Submitting a maintenance request is always free- see our Terms of Service.